I know for certain the password is correct. ![]() ![]() I followed the steps to manually start wpa_supplicant ( sudo wpa_supplicant -c /etc/wpa_supplicant/wpa_nf -i wlan0) and all I am getting is a status_code 16 error 4 times then an auth_faliures=1 error. I honestly I have no idea what I'm doing wrong.Īfter reading this post: Raspi doesn't connect with wifi anymore. After adding them back in and then changing the indentation to 0 spaces, 4 spaces, 1 space and a tab it still didn't work. I then removed the usb ethernet config changes on the SD card but still had no luck. This didn't work after a reboot and using ifdown wlan0 & ifup wlan0 didn't work either. I then tried to use a wpa-supplicant file with my wifi password and SSID: ctrl_interface=DIR=/var/run/wpa_supplicant GROUP=netdev Step 2: install hostapd Hostapd is used to establish the access point. You are able to ping ap0 isn't set because the virtual interface isn't created yet. Check with ip addr and/or systemctl status rvice. ![]() After this, the RPi didn't have an IP under wlan0 as I expected. Interface wlan0 has state UP with an ip address 192.168.10.2. The first thing I did was to enable USB ethernet and make the ssh file so I can connect to it over SSH, I then used raspi-config to setup WiFi. I have been trying to setup a raspberry pi 0w to connect to my access point but I can't get it to connect.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |